The Restoration.

Le coin des cineastes amateurs.....

Modérateur : Modos

Répondre
Avatar de l’utilisateur
69libero
Gros posteur
Messages : 242
Inscription : jeu. juil. 24, 2014 9:57
Bike : ZRX
Geolocalization : No

The Restoration.

Message par 69libero » sam. févr. 01, 2020 9:43

Take a Zrx 1100 with 200,000km, two young people who love each other with a passion for motorcycles and the cocktail is served.
The project, never attempted before by man, is to disassemble it together, screw to screw, and restore it completely.
Will our heroes manage to save the Zrx from years of carelessness?
Will their love survive?
We will only find out by taking it apart.


Avatar de l’utilisateur
69libero
Gros posteur
Messages : 242
Inscription : jeu. juil. 24, 2014 9:57
Bike : ZRX
Geolocalization : No

Re: The Restoration.

Message par 69libero » ven. févr. 07, 2020 15:14

Round Two:
We dismantled the fork to find out if the stems were straight and recoverable, since there are rust spots. Then it was the turn of the rear wheel, to remove the saddle pad and thoroughly clean the sprocket area from all the disgust that had accumulated over the years.
The front pin did not unscrew even with the pneumatic gun, a vote holding the pin was seized and to unscrew it I had to use an extension for the Allen key.
The pinion instead unscrewed immediately, always with the gun, and was mounted upside down, a common mistake on the Zrx. The aftermarket sprocket has a "spacer" that must be mounted outside, while instead it is usually mounted inside.


Avatar de l’utilisateur
69libero
Gros posteur
Messages : 242
Inscription : jeu. juil. 24, 2014 9:57
Bike : ZRX
Geolocalization : No

Re: The Restoration.

Message par 69libero » mar. févr. 11, 2020 16:23

In the meantime I tried to assemble stuff without reading the instructions, but in the end I had to read them
And then I risked making a mess

Avatar de l’utilisateur
69libero
Gros posteur
Messages : 242
Inscription : jeu. juil. 24, 2014 9:57
Bike : ZRX
Geolocalization : No

Re: The Restoration.

Message par 69libero » sam. févr. 15, 2020 11:13

Third step of the restoration, we would like to disassemble the electrical system and the remainder of the refrigerant one but first it is better to disassemble the exhaust manifolds and carburettors.
We then dismantle the exhaust, and clean the encrusted area, the clutch pump with the actuator and the pipe that starts from the water pump, we put the rear wheel back because I could need the bench and we will have to move it shortly and then we will focus on the carburettors.
Before disassembling the carburetors, the intake hoses must be disassembled, a job that can lead to madness, we have disassembled two, thanks to a lot of WD40 and an Allen key of 10, the other two I disassembled them during lunch break the next day.

Avatar de l’utilisateur
69libero
Gros posteur
Messages : 242
Inscription : jeu. juil. 24, 2014 9:57
Bike : ZRX
Geolocalization : No

Re: The Restoration.

Message par 69libero » ven. févr. 21, 2020 19:11

In this episode, which is almost 30 minutes long, we filmed the disassembly of the carburetors, the electrical system, the airbox, the water pump and the clutch.
Problems encountered: incorrectly mounted oil filter, clutch plate filed by the alternator chain tensioner.

Avatar de l’utilisateur
Duc de Normandie
ZRX CdF membre n° 100 Président
ZRX CdF membre n° 100 Président
Messages : 16458
Inscription : mer. déc. 28, 2005 17:59
Bike : 1100 N+Satelis 500+ Speed Triple '17
Geolocalization : Yes
Localisation : Igoville (27) ex:1100 N 98 Violine-Draaghan & S bleu/noir 03

Re: The Restoration.

Message par Duc de Normandie » sam. févr. 22, 2020 0:58

Cela pourrait être sympa à suivre mais l'anglais et moi..... :ymdaydream:
Image

Avatar de l’utilisateur
69libero
Gros posteur
Messages : 242
Inscription : jeu. juil. 24, 2014 9:57
Bike : ZRX
Geolocalization : No

Re: The Restoration.

Message par 69libero » sam. févr. 22, 2020 17:35

Never too late to learn something different :grin1:

Avatar de l’utilisateur
Tibo.barbe
Squatteur
Messages : 1601
Inscription : jeu. mai 05, 2016 15:53
Bike : Sv650 cb750 zrx1200s 125rebel
Geolocalization : No
Localisation : Dijon

Re: The Restoration.

Message par Tibo.barbe » sam. févr. 22, 2020 19:59

Wate i sai ?

Envoyé de mon W-V800-EEA en utilisant Tapatalk

Plus qu'on avance, moins qu'on fait face, c'est ça hein chef ?

Avatar de l’utilisateur
MANXR
ZRX CdF membre n° 83, manxr gyver le roi des bricoleurs
Messages : 7152
Inscription : lun. juil. 09, 2007 2:12
Bike : Essence, bruyant et qui pousse. EELV approved!😘😂
Geolocalization : No
Localisation : 83

Re: The Restoration.

Message par MANXR » sam. févr. 22, 2020 22:29

Duc de Normandie a écrit : sam. févr. 22, 2020 0:58 Cela pourrait être sympa à suivre mais l'anglais et moi..... :ymdaydream:
Ma, è anche posibile da vedere la ristorazionne sulla sua pagina yt, ma chè, mama mia !! :mrgreen: :)) :wink:
Je ne sais pas si ça plait, mais je sais ce que j'aime!

Avatar de l’utilisateur
69libero
Gros posteur
Messages : 242
Inscription : jeu. juil. 24, 2014 9:57
Bike : ZRX
Geolocalization : No

Re: The Restoration.

Message par 69libero » mar. févr. 25, 2020 18:31

In the fifth episode the much coveted extraction of the engine from the chassis, being all very heavy, we did calmly and without unnecessary effort.
First we put a jack under the flat part of the engine, then we removed the front end, we placed the engine on the bench still anchored to the frame. We then removed the rear axle and resting the engine on the side we removed the pins that keep it fixed to the frame we removed the vents on the head and the plastic behind the radiator fan that obstructed the movements.
Finally, turning the engine sideways we managed to remove the frame, then we cleaned the part that will have to be attached to the engine support.


Avatar de l’utilisateur
JusteAlex
Proprio
Messages : 694
Inscription : sam. mai 25, 2013 18:11
Bike : ZRX1200S 163000km...
Geolocalization : Yes
Localisation : Voiron - 38

Re: The Restoration.

Message par JusteAlex » mar. févr. 25, 2020 19:57

Sacré beau et grand projet, j'adore! :-bd
Andrea, un grand merci pour le partage! Continue(z) comme ça, et vivement le remontage (et les autres épisodes :ymwink: )
Interceptor: Image
Carnaby: Image

Avatar de l’utilisateur
69libero
Gros posteur
Messages : 242
Inscription : jeu. juil. 24, 2014 9:57
Bike : ZRX
Geolocalization : No

Re: The Restoration.

Message par 69libero » sam. févr. 29, 2020 12:11

JusteAlex a écrit : mar. févr. 25, 2020 19:57 Sacré beau et grand projet, j'adore! :-bd
Andrea, un grand merci pour le partage! Continue(z) comme ça, et vivement le remontage (et les autres épisodes :ymwink: )
Thank you!

Avatar de l’utilisateur
69libero
Gros posteur
Messages : 242
Inscription : jeu. juil. 24, 2014 9:57
Bike : ZRX
Geolocalization : No

Re: The Restoration.

Message par 69libero » sam. févr. 29, 2020 12:12

The labors of Hercules? A no brainer compared to having to dismantle a 6-year-old rubber by hand as dry as a dog poop in the sun.
After almost 25 minutes I win the challenge and after a refreshed attack the front tire but with due care .... but you will see this in the next episode.


Avatar de l’utilisateur
69libero
Gros posteur
Messages : 242
Inscription : jeu. juil. 24, 2014 9:57
Bike : ZRX
Geolocalization : No

Re: The Restoration.

Message par 69libero » mer. mars 04, 2020 9:49

Image

Image

meanwhile.....brand new calipers

Avatar de l’utilisateur
69libero
Gros posteur
Messages : 242
Inscription : jeu. juil. 24, 2014 9:57
Bike : ZRX
Geolocalization : No

Re: The Restoration.

Message par 69libero » mer. mars 04, 2020 10:23

And here's the disassembly of the front, I filled the sprayer with soap and water and after removing the brake discs (they were finished) I watered it with soap and water, this time it was much easier to disassemble it!


Avatar de l’utilisateur
69libero
Gros posteur
Messages : 242
Inscription : jeu. juil. 24, 2014 9:57
Bike : ZRX
Geolocalization : No

Re: The Restoration.

Message par 69libero » jeu. mars 12, 2020 16:42

And now away the wheel bearings that were seized.


Avatar de l’utilisateur
69libero
Gros posteur
Messages : 242
Inscription : jeu. juil. 24, 2014 9:57
Bike : ZRX
Geolocalization : No

Re: The Restoration.

Message par 69libero » lun. mars 08, 2021 3:18

after 1 year we started work again

Avatar de l’utilisateur
69libero
Gros posteur
Messages : 242
Inscription : jeu. juil. 24, 2014 9:57
Bike : ZRX
Geolocalization : No

Re: The Restoration.

Message par 69libero » lun. mars 15, 2021 1:56


Avatar de l’utilisateur
69libero
Gros posteur
Messages : 242
Inscription : jeu. juil. 24, 2014 9:57
Bike : ZRX
Geolocalization : No

Re: The Restoration.

Message par 69libero » jeu. nov. 04, 2021 17:40

Enfin de retour au travail !
Nous avons démonté la cloche d'embrayage, la chaîne côté alternateur, le démarreur, le disque d'allumage et la chaîne de distribution, le carter côté boîte de vitesses et l'arbre de transmission et enfin le carter d'huile et les tuyaux d'huile extérieurs.
La vis qui tenait le disque d'allumage était trop serrée et était déjà dévêtue, la chauffant beaucoup nous avons réussi à la débloquer, nous allons certainement la changer.
Nous n'avons pas pu, faute de temps, séparer les couvercles de carter.
À l'intérieur de la tasse, nous avons trouvé en plus de la limaille d'aluminium également des boucles métalliques, elles ressemblent à des morceaux de filet.
Et voici la vidéo !


Répondre